Ductile Iron EN-GJS-450-10/ASTM A536 65-45-12

Ductile Iron EN-GJS-450-10/ASTM A536 65-45-12

Ductile Iron EN-GJS-450-10/ASTM A536 65-45-12 is an excellent grade material.

This grade is equal to QT450-10 in China; GS400-12 in Italy; FCD400 in Japan; FGS400 in France; FNG42-12 in Belgium; SJK-400 in Norway and ISO 1083 450-10.

Yide Casting has producing this material grade for many years. Herein, we will share the mechanical properties, chemical composition, foundries and castings of EN-GJS-450-10 for you.

Properties of EN-GJS-450-10 cast iron

Tensile strength ≥ 450 Mpa.
Yield strength ≥ 310 Mpa.
Elongation ≥ 10%.
As for A536 65-45-12, its elongation ≥ 12%. And the other properties are the same as EN-GJS-450-10

Ductile cast iron EN-GJS-450-10 has high tensile strength, high elongation, and good impact resistance.  Therefore, this grade is very widely used.

Hardness of EN-GJS-450-10 cast iron

The hardness of this ductile cast iron grade is between 160-210 Brinell hardness.

Chemistry composition of EN-GJS-450-10 cast iron

According to the standard DIN EN 1563, the foundries could adjust the chemical composition as long as the mechanical and physical properties of the castings could meet the requirements in Standards.

The following chart is an approximate chemical composition range for your reference.

C: 3.50-4.00, Si: 2.20-2.90, Mn: 0.3-0.6, P: 0.03-0.06, S: 0.02-0.040, Mg: 0.020-0.060.

DIN EN 1563 ISO C % Si % Mn % P % S % Mg %
EN-GJS-450-10 450-10 3.5-4 2.2-2.9 0.3-0.6 0.3-0.6 0.02-0.04 0.02-0.06

Foundry of EN-GJS-450-10 cast iron

Because of the comparatively high elongation, EN-GJS-450-10 ductile iron could be used for producing impact resistance casting parts. In addition, it has good low temperature impact resistance and good hardness. Thus it has been used for producing plough, plough pile, differential shell, plow point, valve body and high pressure cylinder.

cast iron shell Wheel hub shell Wheel hub shell

 

 

 

 

Yide casting is an experienced casting foundry, specialized in casting iron for 28years, can manufacture the casting iron parts according to your drawing file and requirement. If you are looking for a casting manufacturer, please feel free to contact us for more details, and you are welcome to visit our factory for more details.

 

 

0 replies

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *